A. The title "Parcel Map" in letters one-half inch in height at the top of the map. If a condominium type project, the title "CONDOMINIUM", "CONDOMINIUM CONVERSION", etc., will be added.

B. The name and address of the record owner of the property and the subdivider.

C. The name, address and registration number of the engineer or surveyor preparing the map.

D. Sufficient elevations or contours to determine the general slope of the land, the high and low points thereof, and all drainage features.

E. Dimensions and bearing of all existing and proposed property lines. Proposed property lines shall be designated by a line weight heavier than that used for existing lines and easement lines.

F. The proposed lots or parcels shall be designated "Parcel A", "Parcel B", etc. or if a condominium or similar project, "UNIT 1", "UNIT 2", etc., for reference purposes.

G. The datum, bench mark used, north arrow, scale and basis of bearings.

H. Locations, names and right-of-way widths of all adjoining or abutting streets, alleys or ways.

I. Widths, locations, and purposes of all existing and proposed easements.

J. The locations and outline of all existing drainage structures, building structure and retaining walls on the property.

K. The location of all hydrants, drainage structures, curbs, driveways, sidewalks, utility poles, major trees showing size, and building structures within a fifteen-foot strip outside of and adjacent to the exterior boundary of the property involved.

L. A certificate, signed and acknowledged by all parties having any record title interest in the land subdivided, consenting to the preparation and recordation of said map.

M. A certificate by the registered civil engineer or licensed land surveyor responsible for the survey and the map. If a field survey was performed, the certificate shall conform to the requirements of Section 66445(i) of the Subdivision Map Act.

N. A certificate for execution by the City Engineer.

O. A certificate for execution by the secretary of the Planning Commission.

P. A certificate for execution by the county recorder as required by the Subdivision Map Act.

Q. A certificate of the clerk of the board of supervisors as required by the map act.

R. The identifying number on the lower right-hand corner in characters one-half inch in height, pre-fixed with the letters "PM".

S. Delineation of all survey marks found or set by the engineer or surveyor.

T. A border shall be delineated approximately one inch from the edge of the sheet.

U. A description of the real property (lot, block, and tract, etc.), at the bottom right of the map.

V. A preliminary title report prepared within three months prior to filing the parcel map.

W. A soils and/or engineering geology report as may be required by the City Engineer.

The City Engineer may waive any of the foregoing requirements upon finding that the location or nature of the proposed minor subdivision is such as not to necessitate compliance with these requirements; or may require additional information as deemed necessary. (Ord. 5793-NS § 2 (part), 1987)